3 kinked water line internally.
Elkay water fountain bottle filler troubleshooting.
Elkay filtered water coolers.
Open shut off valve.
2 regulator valve defective.
Kits are available with and without a filter status monitor and.
Today elkay plumbing products delivers world class innovations for sinks faucets foodservice products water coolers drinking fountains and award winning rapid bottle filling stations.
Elkay is an american owned and operated company with 100 years of experience.
Be sure to reinstall fuse to the circuit or switch the circuit breaker back to the on position.
Turn on water supply.
Locate affected line remove kink.
Identified your issue and need parts.
Complete cooler and bottle filling station in a consolidated space saving ada com.
Clean or replace strainer screen.
How to replace an elkay ezh2o water filter.
Our filters are also sold separately and can be retrofitted onto any existing elkay or non elkay branded water cooler fountain or bottle filling station with elkay s vandal resistant retrofit filtration kit.
Strainer screen is plugged with debris.
Turn on the water supply plug unit into wall power cord not supplied on 220v models and activate the electronic eye on in wall bottle filler until approximately 1 gallon of water is dispensed.
No water flow on all other water coolers fountains.
Water stream is too low.
The elkay ezh2o bottle filling station delivers a clean quick water bottle fill and enhances sustainability by minimizing our dependency on disposable plastic bottles.
Elkay filtered bottle filling stations.
Elkay water fountain troubleshooting water stream from bubbler is too high below is a numbered list of the most popular potential causes of high flow bubbler stream along with corrective actions to take to troubleshoot them.
Ezh2o bottle filling station clean care troubleshooting.
Elkay drinking fountain troubleshooting guide find the solution to your problem and parts with the following guide.
Family owned since 1920 celebrating 100 years.
For newly installed water coolers the water pressure in your facility may be higher than factory test conditions.
Water is freezing up in evaporator.
Water shut off valve not open.
